Brief: A hiker is stranded on a ridge no vehicle can reach. Your rig must hang below a delivery drone and release a supply pack remotely, without landing.
π¦ Payload (supply pack) must not exceed 500 g
βοΈ Total rig weight (frame + release mechanism, empty) must not exceed 700 g so the drone can still carry the payload within its lift limit
π₯ The rig must survive a 2 m drop test onto rock without breaking
π‘ The release must be triggerable remotely β no manual pin-pulling
Choose a frame material. Every material trades weight against durability.
Choose a release mechanism. It has to work by remote signal β no exceptions.
Frameβ
Mechanismβ
Rig Weightβ
Testing your prototype against every constraint from the brief.
Finish Model and Prototype first.
Iterate: Whether your design passed or failed, a real engineer writes down what they'd change next and why. Do that now.
Engineering Systems & Electronics Β· Capstone Β· Grades 11β12
Engineering Design Process Studio
DefineModelPrototypeTestIterate
Every lesson in this module has been one piece of the engineering process: reading parts, wiring circuits, tuning feedback loops, sizing structures. This capstone walks the whole loop at once, against one real, constraint-driven brief β and asks you to defend the tradeoffs you make, not just pick an answer.
The Design Loop
Real engineering is a loop, not a straight line from idea to finished product. You define the problem, build a model of a solution, prototype it, test it against reality, and use what you learn to go back and improve it. Work through all five stages below for one brief: a drone rig built to drop emergency supplies to a stranded hiker.
Practice Problems
Easy1. Put the design loop in order: Test, Define, Iterate, Model, Prototype.
Hint: You can't build a model of a problem you haven't defined yet, and you can't test something that doesn't exist.
Easy2. Why is "Iterate" a loop back to earlier stages instead of a final step?
Hint: Real designs are rarely right on the first try β that's exactly why it's a loop, not a line.
Medium3. In this studio, why does the brief cap the empty rig weight at 700 g instead of just capping the payload?
Hint: A drone doesn't distinguish "rig weight" from "payload weight" β it just has one total weight limit.
Medium4. If a lightweight frame fails the drop test, what's the most useful next step?
Hint: This is the loop in action β a failed Test sends you back to Model to weigh a new tradeoff, not to give up.
Challenge5. Why does the brief require a remote release instead of allowing a simple manual pin a rescuer pulls by hand?
Hint: Re-read the brief β the drone isn't landing, so nobody is there to pull a pin.